Another shot of the BMS
BMS Cell modules
3 of the 45 Sky Energy SE180AHA Batteries
The rest of them..
Engine crane
4kw Fluid heater
1200A 50mV shunt (for Cycle Analyst)
Vacuum Pump
DC/DC Converter
Power Cable - Fat 95mm^2
Conduit - Regulation Orange
Tuesday, February 23, 2010
Subscribe to:
Post Comments (Atom)
I have the same batteries as you. I read on the web page for Jack Rickard that it is a good idea to charge the cells to 3.5V instead of 3.6V as the manufacturer says. I have tested this on my cell, and after that, the entire battery pack balangsert after the first charge. Before I read about it, I had charged up to 3.6V and then I had problems with the battery pack was not balangsert. Just a tip
ReplyDeleteRegards
Øyvind Holst
Norway